X-ray source hanger for a robot
2 halves clamp around the handle of an x-ray source so that the source always hangs level
A robot gripper grabs the round section to carry the source
By pulling a pin the handle of the hanger can pivot and the source will always point forward and level no matter the orientation of the robot gripper
Leaving the pin in place allows the robot to swing the source up if needed and the handle of the source can be held in place with a piece of foam pipe insulation
Made of lightweight and durable delrin plastic and fiberglass pole
Tool less operation with thumb screws to attach the 2 halves of the hanger
Larger hole for the handle of the source (Panel hanger is 5770)
Picatinny rail on top to mount relay switch (5775) to fire x-ray source from the robot
Can be used in a 2 robot scenario with another robot carrying the panel
