Duke Shock Tube Saver System

Duke Shock Tube Saver System

(No reviews yet) Leave a Review
Part #:
5065
Maximum Purchase:
99999 units

Item # 5065

Approved for use for all armed services.

The Shock Tube Saver System is a kit consisting of a power pack, a single-channel shock tube initiator, and 500 feet of lead line on a spool.

The system is designed to allow the user to reduce shock tube consumption by at least 95%.

Instead of running 500 feet of shock tube downrange, you can run 25 to 50 feet of shock tube from the shot to the rugged initiator. You then use 500 feet of lead line to run from the initiator back up range. The power pack is used to power the initiator through the lead line from a safe distance.

The initiator and lead line can be recovered for reuse resulting in the use of only 25 feet of shock tube instead of the 500 feet. In this manner, the system pays for itself within 25 shots.

In addition to the cost savings, this also means that you have less shock tube that needs to be transported to a remote site, less to haul back out, and less to account for, allowing the user to fire more shots per reel of shock tube.

Over $400,000 can be saved in shock tube cost alone over the 10,000-shot life span of the system. As with all of our other commercial products, this system is covered by our No Nonsense Guarantee. If it breaks, send us the pieces and we'll repair or replace it at no cost.

</table

Specifications
Dimensions (LxWxH): Initiator: 5.7" x 3.7" x 2.0"
Power Pack: 5.2" x 2.44" x 2.28"
Weight: Initiator: 1.1 lbs.
Power Pack: 0.4 lbs. (including batteries)
Power Supply: Three standard 9-Volt alkaline batteries.
Maximum Range: 6,000 feet using 16 gauge duplex lead line.
3,900 feet using 18 gauge duplex lead line.
2,400 feet using 20 gauge duplex lead line.
1,500 feet using 22 gauge duplex lead line.
970 feet using 24 gauge duplex lead line.
600 feet using 26 gauge duplex lead line.
385 feet using 28 gauge duplex lead line.
Shock Tube Tip: Fires military, thick walled, and standard commercial shock tube.
Environmentally Sealed: Power pack and downrage initiator are water resistant.
Safety: Downrange initiator will not fire until fully charged to design voltage. Power pack outputs are caged (shorted) until unit is fired. Downrange initiator automatically discharges safely if FIRE button is released. Single button fire control with shrouded switch to prevent inadvertent actuation.
Fast Charge: 2~3 seconds
Long Battery Life: Provides over 1000 charge-fire cycles on one set of batteries.
Military Rated: Safety tested and certified to MIL-STD-461E and MIL-STD-464A.
Operating Temperature: -40C ~ +85C
Initiator Power Requirements: 18 - 30VDC, 210 mA for 2 seconds